Troubleshooting and Maintenance
5-32
9161-A2-GH30-20
September 1997
Starting and Stopping a Test
Use this procedure to start and/or abort specific tests. To abort all active tests on
all interfaces, see
Aborting All Tests
on page 5-33.
When the status of a test is . . .
The only command available is . . .
Inactive
Start
Active
Stop
You start or stop an individual test using the same procedure.
Procedure
To start or stop a test:
1. Follow this menu selection sequence:
Main Menu
→
Test
2. Select a test screen for an interface and press Return. The selected test
screen appears, with the cursor positioned in the Command column of the
first line (available test).
Start or Stop appears in the Command column, and Active or Inactive
appears in the Status column, based upon the test’s current status for that
interface.
3. Select the test you want to start or stop and press Return. The selected test
for the interface changes from Stop to Start, or from Stop to Start, also
changing the status of the test.
4. Press Return again to start or stop the test.
