Setting Up
4-34
9161-A2-GH30-20
September 1997
Assigning Cross Connections
The system allows you to assign data paths between the various interfaces to
share the T1 network. Assuming that both the Network and DSX-1 interfaces are
enabled and that at least one voice port APM is installed, you can make the
following cross connections:
Assign DSX-1 time slots to the Network interface
Assign Network 2 interface timeslots to the Network 1 interface
Assign voice ports to DSX-1 or Network interface timeslots
Assign Sync Data ports to DSX-1 or Network interface timeslots, or to
another Sync Data port
You can also clear cross-connection assignments.
NOTE:
Although it is not required, it is suggested that you progress through each
screen in order, from top to bottom.
Use the worksheets in Appendix A and the following procedures to assign cross
connections.
