Displaying System Information
4-7
9621-A2-GB20-30
August 1997
Message
What To Do
What It Indicates
Excessive BPVs
hhh:mm:ss
2
An excessive number of
bipolar violations has been
detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
Caused when at least one
invalid BPV has occurred
every 20 ms for 2 seconds.
Verify that the network cable is
securely attached at both ends.
ISDN Active
An ISDN call is active.
Only appears when a dial
backup module (DBM) is
installed.
No action needed.
ISDN Network Failed
(Active/ Idle)
An ISDN network failure
was detected when:
Active – Backup call was
in progress.
Idle – DBM was in Idle
mode.
Only appears when a dial
backup module (DBM) is
installed.
Contact network provider if
problem persists.
LMI Down,
interface
The Local Management
Interface is down for the
Network, Port-1, Port-2,
BRI-B1, or BRI-B2.
LMI for a BRI interface only
applies when the B channel
is configured as the
originating device/interface
(Originate or Answer
configuration option set to
Originate).
See if the DLCI’s link is active
on the alternate destination
link.
– If it is, no action is required.
– If not, contact network
provider.
Contact network provider if
problem persists.
2
hhh:mm:ss indicates the number of hours (maximum 255), minutes (maximum 59),
and seconds (maximum 59). When the time has been exceeded, 255:59:59+
appears.
