Displaying System Information
4-5
9621-A2-GB20-30
August 1997
Message
What To Do
What It Indicates
Compr Connect Fail,
DLCI
nnnn
1
A compression connection
for the specified Port 1
DLCI is down.
Only appears when
compression is enabled.
Refer to the Troubleshooting
Problem Tables,
Frame Relay
PVC Problems, in Chapter 5 of
the Technical Reference.
The underlying DLCI does
not have Compression
enabled.
Enable Compression for the
DLCI.
Compression is not
configured at both ends of
the PVC.
Enable Compression at both
ends of the circuit.
Both access units on the
PVC do not have the same
compression mode.
Configure access units at both
ends of the circuit so their
compression options are
compatible.
Configuration Shortcut
Active
Configuration Shortcuts
feature is active, which
allows automatic
configuration and
cross-connection of DLCIs
as they are activated by the
network.
No action needed unless you
want to disable this feature,
selected from the Main Menu.
Cross Pair Detection
A cross pair condition has
been detected on the DDS
network interface; RX and
TX pair are reversed.
Reverse the RX and TX pair at
the punchdown block or other
termination point.
DBM Card Failed
One or more of the access
unit’s integrated circuit
chips has failed to loop data
through the DBM circuit
internally.
1. Reset the access unit and try
again.
2. Call your service
representative for assistance.
3. Return the access unit to the
front of this guide).
1
nnnn indicates a DLCI number of 16 through 1007; interface is the Network, Port 1,
Port 2, or the basic rate interface B channel.
