Displaying System Information
4-8
9621-A2-GB20-30
August 1997
Message
What To Do
What It Indicates
Low Compr Ratio,
DLCI
nnnn
1
The compression ratio for
the specified DLCI on
Port 1 has fallen below the
threshold that had been
configured.
Only appears when
compression has been
enabled.
If not a temporary condition:
Raise the Compression Ratio
Threshold from the ( Path:
main/configuration/edit/
user/com).
Disable the Compression
Ratio Alarm.
Check the type of data being
compressed for its
compressibility.
Disable compression if data is
already being compressed.
NAM Download Failed
A download attempt was
interrupted and failed to
complete; an invalid control
file was downloaded to the
DBM.
Download function is controlled
by and for service personnel
only.
Call your service
representative.
Network Com Link
Down
The communication link for
the COM port is down, and
the COM port is configured
for Net Link.
Check the router connected to
the COM port.
No Signal
hhh:mm:ss
3
A NS condition has been
detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
1. Check for a cross-pair
condition.
2. Verify that the network cable is
securely attached at both
ends.
3. Contact network provider.
Out of Frame
hhh:mm:ss
3
An OOF condition has been
detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
Contact network provider.
Out of Service
hhh:mm:ss
3
An OOS condition has
been detected on the DDS
network interface, followed
by the period of time that
the condition has existed.
1. Check for a cross-pair
condition.
2. Verify that the network cable is
securely attached at both
ends.
3. Contact network provider.
1
nnnn indicates a DLCI number of 16 through 1007; interface is the Network, Port 1,
Port 2, or the basic rate interface B channel.
3
hhh:mm:ss indicates the number of hours (maximum 255), minutes (maximum 59),
and seconds (maximum 59). When the time has been exceeded, 255:59:59+
appears.
