Maintenance and Troubleshooting
5-12
9621-A2-GB20-30
August 1997
Message
What To Do
What It Indicates
Set Frame Relay Link
Status to Disable first
Tried to disable the physical
port when the logical link
was up; tried to change
Port Status to Disable while
Link Status was enabled.
1. Change Link Status to
Disable.
2. Retry disabling the port.
Value Out of Range
CIR entered for the DLCI is
a number greater than
64,000, or is a special
character.
Enter a valid CIR ( 0 – 64000 ).
Excess Burst Size entered
for the DLCI is a number
greater than 999,999, or is
a special character.
Enter a valid Excess Burst Size
( 0 – 999999 ).
DLCI Number entered is
less than 16 and greater
than 1007.
Enter a valid number
(16 – 1007 ).
Device Status Messages
These messages appear in the messages area at the bottom of the screens.
Message
What It Indicates
What To Do
Already Active
Test selected is already
running.
Allow test to continue.
Select another test.
Stop the test.
Backup Active
Backup has been
established and data is
flowing over the alternate
DLCI.
No action needed.
Blank Entries
Removed
New had been selected
from the Administer Logins
screen, no entry was made,
then Save was selected.
No action needed.
Re-enter the Login ID,
Password, and Access Level.
Command Complete
Configuration has been
saved or all tests have
been aborted.
No action needed.
Connection Refused
User interface is in use;
access unit already
accessed.
Wait and try again.
