17
!
Important Safety Instructions
1. Read and follow all warning notices and instructions marked on the product or
included in the manual.
2. All installation and service must be performed by qualified service personnel, as
opening or removing covers may expose you to dangerous high voltage points or
other risks.
3. The power supply to be used with this product is intended to be used with a 3-wire
grounding type plug – a plug which has a grounding pin. This is a safety feature.
Equipment grounding is vital to ensure safe operation. Do not defeat the purpose
of the grounding type plug by modifying the plug or using an adapter.
Prior to installation, use an outlet tester or a voltmeter to check the ac receptacle
for the presence of earth ground. If the receptacle is not properly grounded, the
installation must not continue until a qualified electrician has corrected the
problem.
If a 3-wire grounding type power source is not available, consult a qualified
electrician to determine another method of grounding the equipment.
4. Input power to this product must be provided by a power supply with a Safety Extra
Low Voltage (SELV) output less than 240 VA available, certified for use in the
country of installation.
Paradyne power supply part number 327-0107-0031 is recommended. This power
supply includes a special mating connector for connection to this equipment.
5. Slots and openings in the cabinet are provided for ventilation. To ensure reliable
operation of the product and to protect it from overheating, these slots and
openings must not be blocked or covered.
6. Do not allow anything to rest on the power cord and do not locate the product
where persons will walk on the power cord.
7. Special cables, which may be required by the regulatory inspection authority for
the installation site, are the responsibility of the customer.
8. When installed in the final configuration, the product must comply with the
applicable Safety Standards and regulatory requirements of the country in which it
is installed. If necessary, consult with the appropriate regulatory agencies and
inspection authorities to ensure compliance.
9. A rare phenomenon can create a voltage potential between the earth grounds of
two or more buildings. If products installed in separate buildings are
interconnected, the voltage potential may cause a hazardous condition. Consult a
qualified electrical consultant to determine whether or not this phenomenon exists
and, if necessary, implement corrective action prior to interconnecting the products.
