18
5.
If the DS3 source device has a variable line build out (LBO) setting, ensure that it is
matched to the cable length.
NOTE:
After connecting the network cable, wait about a minute to allow Auto-
Configuration a chance to discover the frame relay characteristics and DLCIs.
Verification Check:
❑
Check the System ALM (Alarm) LED. Is it off? Check the Network LEDs. Are the TD
and RD LEDs blinking, and are the OOF, LOS, AIS, and YEL LEDs off?
—
If yes, the network interface is set up correctly and is ready to pass data.
—
If no, check that both ends of the network cable are properly seated, then verify
that the network physical options are configured correctly.
Main Menu
→
Configuration
→
Network
→
Physical
❑
Check the LMI LED. Is it on?
—
If the LMI LED is off for more than three minutes, check the System and Test
Status screen for error messages.
Main Menu
→
Status
→
System and Test Status
Refer to the
FrameSaver SLV Operations Guide (9000-A2-GB33)
for possible
reasons for the messages and what can be done to resolve the problem.
Net RX
Net TX
DS3
Network
Interface
00-16778
1
2
3
5
4