Installation and Setup
2-15
5100-A2-GB21-10
April 1997
Saving Configuration Settings
When you first install the software or whenever you change switch settings, you
need to save these settings to the
protocol.ini file. If you are using more than one
TCP/IP package (e.g., Windows TCP/IP, Trumpet, Chameleon, etc.) on the same
machine, you need to save the switch settings to the
protocol.ini file for each
package. If you attempt to save but the file cannot be found or you need to
change the path, refer to
Checking/Setting Protocol.ini Path
for information.
Procedure
To save the configuration settings:
1. Select File from the HotWire main
menu.
2. Select Save.
The Save window
appears. This window
uses the standard
Windows user
interface conventions.
3. Verify the pathname
for the
protocol.ini
file (not applicable to
Windows 95).
4. Click on one of the
following:
— OK to accept the parameters and return to the main menu.
— Cancel to close the window without accepting any values and return to
the main menu.
