Telephone Network Interface Device (NID)
99-16633
Existing POTS
Wiring to
Telephone
Customer Premises
TIP
RING
TIP 2
RING 2
TIP 3
RING 3
TIP
RING
FILTER IN
FILTER OUT
99-16601
Filter In
2
Installing the Hotwire 6040 MVL Wall Jack Phone Filter
"
Procedure
1. The local loop provides dial tone
and terminates at the NID (Network
Interface Device) at the customer
premises. Disconnect the existing
POTS wiring on the customer
premises side of the NID.
!
WARNING:
Do not continue unless
the existing POTS wiring
has been disconnected.
Refer to Important Safety
Instructions, page 3.
2. Remove the wall-mount phone from the
existing wall jack by sliding up and off existing
wall jack.
3. Disconnect the wires from the existing wall jack.
4. Remove the four screws from the filter faceplate
and set the faceplate aside.
5. Connect the wires disconnected in Step 3 to
the screw terminals of the wall jack phone
filter as follows (your wiring colors may differ):
— Red: FILTER IN TIP
— Green: FILTER IN RING
6. Fasten the filter assembly to the wall box
using the screws that held the old wall jack.
An engraving on the filter assembly (UP
↑
)
shows the proper orientation.
7. Fasten the faceplate to the filter assembly.
8. Reattach the wall-mount phone to the new
wall jack.
9. Reconnect the wiring to the local loop at the NID.