6050-A2-GZ40-20
August 2001
13
Installing the POTS Splitter Card
HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
Procedure
To install a POTS splitter card into the POTS splitter chassis:
1. Remove the slot filler panel, if necessary, by loosening the 1/4-turn fastener on
either side. Keep filler panels in all unused slots.
2. Slide the POTS splitter card into the chassis.
3. Tighten the 1/4-turn fastener on each side of the faceplate of the POTS splitter
card.
!
TM
DSL Interface
Loop Interface
PSTN Interface
99-15431-01
CO POTS Splitter
6-Slot Chassis
1/4-Turn
Fastener
1/4-Turn
Fastener
Filler
Panel