Initial Setup Instructions
3-2
7900-A2-GB20-00
March 1998
Entering Initial Network Configuration (Netconfig)
Parameters
The recommended order for entering network configuration parameters is:
H
MTU-M IP address
H
Subnet Mask
H
Default Gateway
H
SNMP Manager Address
H
Default Gateway Address
H
System Name, Contact, and Location
NOTE:
The default values are recorded in Appendix B,
Netconfig and Sysconfig
Menu Values
. When changing network configuration values, it is helpful to
write the values down in the table provided in
Appendix B
for future
reference. Default values have ben provided.
"
Procedure
To enter initial network configuration parameters information:
1. At the MTU-M–> prompt, type m.
The Maintenance menu displays.
2. At the maint–> prompt, type net.
The Netconfig menu displays. This screen contains the current network
management information.
3. At the netconfig–> prompt, press Enter.
A prompt appears asking you if you wish to change the current values.
4. Type y at the
yes/no
prompt and press Enter.
The system displays the default settings.
5. Type new at the password prompt. You can change your password from the
Network Parameters menu.
The changes you make at the Netconfig menu are stored in a working buffer.
If you make an error or are unsure of your changes, do not save your
changes. The system will return to the previous values.
6. Change Netconfig menu option values as required. Refer to
Changing
MTU-M Network Parameters (netconfig)
in Chapter 6,
MTU-M Maintenance
Functions.
7. Type q to exit the Netconfig menu.
8. At the
yes/no
prompt, type
y and press Enter to save your changes.
Summary of Contents for HOTWIRE 7900
Page 8: ...Contents iv 7900 A2 GB20 00 March 1998 This page intentionally left blank ...
Page 28: ...System Terminal Interface 4 6 7900 A2 GB20 00 March 1998 This page intentionally left blank ...
Page 72: ...Testing 9 12 7900 A2 GB20 00 March 1998 This page intentionally left blank ...
Page 82: ...Glossary GL 4 7900 A2 GB20 00 March 1998 This page intentionally left blank ...