4-1
7900-A2-GB20-00
March 1998
System Terminal Interface
4
Connecting a System Terminal
You can connect a system terminal directly or through a modem to the MTU-M
front panel. The system terminal must be a VT100-compatible terminal or a PC
running emulation software.
The system terminal provides a menu-driven interface to the MTU-M card that
allows you to:
H
Monitor the status of HDSL and SDSL nest card termination units (xTUs)
configured as central site/office (CO)
(xTU-Cs)
H
Monitor the status of associated customer premises (CP) termination units
(xTU-R)
H
Perform loopback testing on xTU-C/R pairs
H
Change MTU-M operational and network parameters
H
Reset the unit
NOTE:
The MTU-M monitors only those nest card termination units configured as
central office/site (CO) (xTU-C). The status of an xTU-C’s associated CP
configured unit (xTU-R) is monitored through the
xTU-C.
Summary of Contents for HOTWIRE 7900
Page 8: ...Contents iv 7900 A2 GB20 00 March 1998 This page intentionally left blank ...
Page 28: ...System Terminal Interface 4 6 7900 A2 GB20 00 March 1998 This page intentionally left blank ...
Page 72: ...Testing 9 12 7900 A2 GB20 00 March 1998 This page intentionally left blank ...
Page 82: ...Glossary GL 4 7900 A2 GB20 00 March 1998 This page intentionally left blank ...