2
August
2000
8303-A2-GZ40-10
8303/8304 IDSL Card Installation Planning
Each Hotwire chassis is shipped with one of the following installation
documents:
Refer to one of the above installation documents to:
— Install and set up the Hotwire DSLAM or GranDSLAM
— Install the Hotwire 8303/8304 IDSL Card
— Connect cables
After the IDSL card is installed, there are configuration procedures that must
be performed before you can begin to use the IDSL cards for Internet or
intranet connectivity. Refer to either the
Hotwire IP MVL, RADSL, IDSL, and
SDSL Cards User’s Guide
or the
Hotwire Shelf Concentration Module (SCM)
Card User’s Guide
for detailed configuration procedures. Access these
documents using the instructions in
Product Documentation Online
on page 1.
HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
Document Number
Document Title
8610-A2-GN10
Hotwire 8610 DSLAM Installation Instructions
8810-A2-GN11
Hotwire 8810 DSLAM Installation Instructions
8820-A2-GN20
Hotwire 8820 GranDSLAM Installation Guide
!
