B. Standards Compliance for SNMP Traps
B-4
April 2003
8799-A2-GB20-10
The tests that affect the enterpriseTestStart, enterpriseTestStop, and the
variable-bindings are different for each particular interface. Diagnostic tests are
only supported on the physical network and user data port interfaces. The specific
tests and variable-bindings are described in the following table:
Interface
enterpriseTestStart/Stop
Variable-Bindings
Possible Cause
SHDSL
Network
ifIndex (RFC 2863)
ifAdminStatus (RFC 2863)
ifOperStatus (RFC 2863)
ifType (RFC 2863)
ifTestType (RFC 2863)
The following objects control tests
in SNMP-managed devices:
– noTest – Stops the test in
progress.
– testLoopLLB – Initiates a Local
Loopback.
– testLoopRLB – Initiates a
Repeater Loopback.
– testSendMon511 – Initiates a
Send and Monitor 511 test.
– testSendLLBUp – Initiates an
LLB Up message to the remote
device.
– testSendLLBDown – Initiates
an LLB Down message to the
remote device.
enterpriseTestStart – Any one
of the following tests is active
on the interface:
– Line Loopback
– Repeater Loopback
– Remote Line Loopback
– Send and Monitor 511
enterpriseTestStop – No tests
currently running on the
interface.
G.703
ifIndex (RFC 2863)
ifAdminStatus (RFC 2863)
ifOperStatus (RFC 2863)
ifType (RFC 2863)
ifTestType (RFC 2863)
The following objects control tests
in SNMP-managed devices:
– noTest – Stops the test in
progress
– testLoopDTLB
enterpriseTestStart – DTE
Loopback is active.
enterpriseTestStop – No tests
currently running on the
interface.
