A. Configuration Options
A-24
April 2003
8799-A2-GB20-10
The following screen is displayed for a DSL port on a G.703 card:
Select Clear_All to clear all time slot assignments for the port.
For an example showing how to configure the cross-connection system, see
Appendix C,
Cross-Connecting Ports
.
Refer to
Table A-9, Assign Time Slots Options
, for additional information about
these entries.
NOTES:
— If a G.703 port is configured for Signaling_CAS, time slot 16 is used for
signaling and is not available for cross-connection.
— Make sure that the number of DSL time slots defined are supported by the
DSL line rate. The maximum number of useful DSL time slots depends on
the configuration (see
Table A-2, Payload Rates and DSL Line Rates for
G.703
). Useful DSL time slots are contiguous and start at Time Slot 1.
main/config/cross_connect/timeslot
Slot: 18 Model: 8799
ASSIGN TIME SLOTS
DSL Port: 1 DSOs to Allocate: Start TS: Assign To: D
TS01 TS02 TS03 TS04 TS05 TS06 TS07
G d G d G d G d G d G d G d
TS08 TS09 TS10 TS11 TS12 TS13 TS14
G d G d G d G d G d G d G d
TS15 TS16 TS17 TS18 TS19 TS20 TS21
G d G d G d G d G d G d G d
TS22 TS23 TS24 TS25 TS26 TS27 TS28
G d G d G d D d D d D d D d
TS29 TS30 TS31
D d D d D d
Key: D = DSL, G = G.703 I = IBMC
d = data, v = voice
--------------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu MainMenu Exit
Save Clear_All
Port Type
(D = DSL
(
G = G.703
I = IBMC)
Port Number
(1–8)
Time Slot Number
(1–31)
d (
Data
) or v (
Voice
)
TS01
D 1 01 d
