7
4.
CONNECT TO PC OR ETHERNET HUB.
Use an 8-pin Ethernet cable (crossover
or straight-through) for the Ethernet connection. Insert one end of the cable into the
jack labeled ETHERNET.
Connect to one of the following:
—
PC.
Use an Ethernet crossover
cable and connect the other end to
a PC with an Ethernet Network
Interface Card (NIC) installed.
– or –
—
Ethernet Hub.
Use an Ethernet
crossover cable and connect the other
end to an Ethernet hub’s Uplink port.
(To connect to a hub’s standard port,
use an Ethernet straight-through
cable).
5.
CONNECT TO POWER.
Insert the supplied power cord’s
round end into the jack labeled POWER. Plug the
transformer into an AC outlet.
When the power cord is installed, the ReachDSL modem
goes through a power-on self-test.
The ReachDSL modem hardware installation is now complete.
For More Information
For more information about the Hotwire DSL systems, visit
www.paradyne.com
. Select
Support
→
Technical Manuals
→
Hotwire DSL Systems
.
ETHERNET
PC with Ethernet
Network Interface
Card
Ethernet
Crossover
Cable
ETHERNET
POWER
ETHERNET
ETHERNET
POWER
Ethernet
Crossover
Cable
Ethernet
Hub
8
7
6
5
4
3
2
1
POWER
POWER
Transformer
