13
Verifying that Self-Test Passed
Procedure
1.
Follow this menu selection sequence from the Main Menu and press Enter after
each selection:
Main Menu
→
Status
→
System and Test Status
2.
Check the Self-Test Results column (in the center of the System and Test Status
screen).
—
If
Passed
appears, the iMarc unit successfully completed the self-test.
—
If any failure messages appear in this column, reset the unit by disconnecting,
then reconnecting the power cord. The unit will perform the self-test again.
If the failure reappears, call your service representative for assistance.
Setting the System Clock
Procedure
To set up the system clock:
1.
Select System Information.
Main Menu
→
Control
→
System Information
2.
Move the cursor to the Date, then the Time field to enter:
—
Date in the mm/dd/yyyy format (month/day/year)
—
Time in the hh:mm:ss format (hours:minutes:seconds)
3.
Save the settings.
Assigning the Node IP Address
Procedure
1.
Set up the node.
Main Menu
→
Configuration
→
Management and Communication
→
Node IP
2.
Minimally, enter the following options:
—
Node IP Address
—
Node Subnet Mask
3.
Save the configuration.
