19
Connecting to the DTE (Router or FRAD)
Procedure
1.
Connect the appropriate cable to the Port connector.
—
If the DTE interface type is EIA-530-A, the DTE can be directly connected to
the Port connector.
—
If the DTE interface type is V.35 or X.21, a V.35 or X.21 adapter cable is
required.
2.
Plug the other end of the cable into the DTE.
3.
Tighten the screws on each side of the connector to secure them.
Verification Check:
❑
Is the Port OK LED on?
—
If yes, the port is set up correctly and is operational.
—
If no, check that both ends of the cable are properly seated and secured.
❑
Check Health and Status messages in the left column of the System and Test
Status screen for messages.
Main Menu
→
Status
→
System and Test Status
—
If
System Operational
appears, the Port interface is set up correctly and
is operational.
—
If
System Operational
does not appear, refer to the
iMarc Operations
Guide
.
NOTE:
When any error conditions are detected, a status message appears along the
bottom right corner of the screen.
98-16200
NTU
DTE
