February 2003
3-33
1000-A2-GH30-00
3. TL1 Commands and Messages
Figure 3–16. Report Alarm Protection Group Format and
Example
REPT ALM PROTGROUP:[TID]
“<protgroup_id>:<ntfcncde>,<condtype>,<srveff>
,
<ocrdat>,<ocrtm>,[<conddescr>]”
CPX-1000 98-06-20 14-30-00
** 001 REPT ALM PROTGROUP
“AID:MN,CONDTYPE,NSA,OCRDAT,OCRTM,FEND,NA,
23,22,15-MIN:
\”LOSS OF HOLDOVER\”,AID,\”OBSERVABLE
BEHAVIOR\”,\”EXPECTED BEHAVIOR\”:
DGNTYPE,TBLISLT”
;
Output Format
Example
Table 3–17.Report Alarm Protection Group Parameters and Description
Parameter
Parameter Type
Description
protgroup_id
This parameter identifies the Protection Group.
protgroup_id is the AID ProtGroup.
ntfcncde
NotificationCode
This is the alarm level. It signals the severity of a
new condition and has a value of CL (Clear) when
this message signals the clearing of a condition.
condtype
ConditionType
This parameter defines the list of conditions or
alarms that occur on a CPX-1000.
srveff
ServiceEffect
This parameter indicates the effect on service
caused by the standing or alarm condition.
ocrdat
Date
This parameter indicates the date when the
specific event or violation occurred.
