PARAGON OUTDOOR OH-M744B, Manual

Assembly Instructions

ASSEMBLY INSTRUCTIONS

Standard 20 lb. tank

11

handling code, B149.2.

lation Code, CSA B149.1, or propane storage and

ANSI Z223.1/NFPA54, natural gas and propane Instal-

the absence of local codes,with national fuel gas code,

The installation must conform with local codes, or in

assembly supplied with the appliance must be used.

full input rating. The pressure regulator and hose

required input rating for a heater at ratings less than

adjustment. The minimum hourly of 16

,

000 Btu/hr is

supply pressure: 5 psi  is required for purpose of input

supply pressure: 250 psi

.

  The minimum inlet gas

or any other enclosed area. The maximum inlet gas

installed and must not be stored in a building, garage

disconnected cylinder must have dust caps tightly

well-ventilated area out of the reach of children. A

appliance. A cylinder must be stored outdoors in a

the cylinder is disconnected and removed from the

Storage of an appliance indoors is permissible only if

department should have this book.

Propane Installation Code. Your local library or fire

ANSI/NFPA 58 or CSA B149.1, Natural Gas and

storage and handling of liquefied petroleum gas,

supply system. See chapter 12 of the standard for

Use this heater only with a propane vapor withdrawal

standard 20 lb. propane cylinder only.

propane gas and cylinder are sold separately.Use a 

11. Connect hose and regulator to cylinder.The 

12

1

12

13

WARNING

After the cylinder is placed inside the heater, 
secure the cylinder with block belt tightly.

13. Install wheel kit to base plate by inserting  

(2) x Bolt M8 x 15mm through the wheel kit and 

base plate and securing them with (2) x Nut M8 
(use supplied wrench to tighten).

Hardware Used

Wrench 

Qty. 1

OO

Bolt M8 x 15mm

Qty. 2

EE

Nut M8

Qty. 2

HH