27
26
Do not push up on the latch releases.
If you do, the camera will not be attached
correctly.
Put the mask strap through the slots of the Mask Mount.
The Mask Mount can be used on either side of your mask.
7.3 THE MASK MOUNT
8.
MAINTENANCE
8.1 CLEANING THE CAMERA
8.2 TRANSPORTING THE CAMERA
8.1.1 Cleaning the O-rings
Always clean the camera in fresh water after use. Check that
the O-rings have not been stretched and that they do not have
any cuts or tears. To lubricate the O-rings apply grease that
does not contain silicone and run them through your fingers
while gently rubbing the grease into the O-ring (do not use
spray lubricant or petroleum based grease).
8.1.2 How do I prevent the camera from flooding?
The triple O-rings are tested to 200 m/656 ft./21 ATM. , so as
long as you properly maintain the O-rings and don’t open the
camera below water you are fine. Remember to screw on the
end cap correctly.
8.1.3 Cleaning the switches
If sand grains get stuck underneath the magnetic switches,
you can easily remove the switches with a small Allen key,
rinse in fresh water, and put them back on. Go to paralenz.com
for more info.
8.1.4 Cleaning the lens
To clean the lens, wipe it with a soft, lint-free cloth. You can use
Eyeglass Cleaning Fluid – but do not use strong solvents such
as benzene or alcohol.
Use the supplied protection pouch when transporting your
Paralenz Dive Camera. There is also room for cables, SD-cards
and silicone grease for the O-rings in the pouch.
