Copyright © Parallax Inc.
Eddie Robot Platform (28990 & 28992)
v1.3 1/16/2013 Page 2 of 17
Additional Items Required
Laptop Computer
Kinect Camera
Philips (cross-head) screwdriver
Scissors
5/32” Allen wrench
Microsoft RDS software
A Keen Imagination
Important Precautions
After switching main board power off, wait at least 5 seconds before switching power back on.
Rapid and repetitive power cycling of the board and motor power supplies causes significant
stress on electronic components and may damage the board and/or connected electronic
accessories.
Use caution when handling the drive motors or Control Board as some components may become
hot after prolonged operation.
As in most electronic devices, Eddie contains components which are sensitive to static discharge.
Exercise proper grounding practices prior to touching or working on the robot.
Assembly Instructions
Note: For pre-assembled Eddie (28992), go to Step 10
Step 1: Motor Mount and Wheel Kits
Pre-assemble the Motor Mount and Wheel Kit and the Caster Wheel Kits, by following the
instructions that came with each of those products. Set them aside for now.
Step 2: Parts Inventory
After you have completed the assembly of the Motor Mount and Wheel Kit and the Caster
Wheel Kits, carefully unpack the remaining components and sort them into their respective
groups. You should have the items listed in the Bill of Materials table below.
