32
Network Camera User Manual
A<-B
: The alarm will be triggered when the intruder/vehicle crosses over the alarm line from
B to A.
Click the “Draw Area” button and then drag the mouse to draw a line in the image. Click the
“Stop Draw” button to stop drawing. Click the “Clear” button to delete the lines. Click the
“Save” button to save the settings.
6. Set the schedule of the line crossing alarm. The setup steps of the schedule are the same as
the schedule recording setup (See
※
Configuration of camera and surrounding area
1. Auto-focusing function should not be enabled for line crossing detection.
2. Avoid the scenes with many trees or the scenes with various light changes (like many
flashing headlights). The ambient brightness of the scenes shouldn’t be too low.
3. Cameras should be mounted at a height of 2.8 meters or above.
4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of
the detected objects should not be more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate
detection.
7. Adequate light and clear scenery are crucial for line crossing detection.
4.4.3
Intrusion
Intrusion
: Alarms will be triggered if the target intrudes and loiters in the pre-defined areas.
This function can be applicable to important supervision places, danger areas and prohibited
areas, like military administrative zones, high danger areas, no man’s areas, etc.
Go to Config
Event
Intrusion interface as shown below.
