36
Network Camera User Manual
Set the alarm area number on the right side. Up to 4 alarm areas can be added.
Click the “Draw Area” button and then click around the area where you want to set as the
alarm area in the image on the left side (the alarm area should be a closed area). Click the
“Stop Draw” button to stop drawing. Click the “Clear” button to delete the alarm area. Click
the “Save” button to save the settings.
6. Set the schedule of the region entrance detection. The setup steps of the schedule are the
same as schedule recording setup (See
* The configuration requirements of camera and surrounding area are the same as intrusion
detection.
4.4.5
Region Exiting
Region Exiting
: Alarms will be triggered if the target exits from the pre-defined areas.
Go to Config
Event
Region Exiting interface as shown below.
