37
Network Camera User Manual
1. Enable region exiting detection and select the snapshot type and the detection target.
Save Panoramic Picture
: If it is enabled, the detected panoramic pictures will be captured
and saved to the SD card when there are targets detected.
Save Target Cutout
: If it is enabled, the detected target cutout pictures will be captured and
saved to the SD card when there are targets detected.
Note
: To save snapshots to the local PC, please enable “Local Smart Snapshot Storage” in the
local config interface first. To save snapshots to the SD card, please install an SD card and
enable “Trigger Snap” first.
Detection Target: See
4.4.2 Line Crossing --Detection Target
for details.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as alarm in (sensor alarm) detection.
Please refer to
chapter for details.
4. Click the “Save” button to save the settings.
5. Set the alarm area of the region exiting detection. Click the “Area” tab to go to the interface
as shown below.
