39
Network Camera User Manual
Test: Test the effectiveness of the IP address by clicking this button.
Use PPPoE-
Click the “PPPoE Config” tab to go to the interface as shown below. Enable
PPPoE and then enter the user name and password from your ISP.
Either method of network connection can be used. If PPPoE is used to connect internet, the
camera will get a dynamic WAN IP address. This IP address will change frequently. To be
notified, the IP change notification function can be used.
Click “IP Change Notification Config” to go to the interface as shown below.
Trigger Email
: when the IP address of the device is changed, the new IP address will be sent
to the email address that has been set up.
Trigger FTP
: when the IP address of the device is changed, the new IP address will be sent to
FTP server that has been set up.
4.5.2
Port
Go to Config
Network
Port interface as shown below. HTTP port, Data port and RTSP
port can be set.
HTTP Port
: The default HTTP port is 80. It can be changed to any port which is not
occupied.
HTTPS Port
: The default HTTPs port is 443. It can be changed to any port which is not
occupied.
Data Port
: The default data port is 9008. Please change it as necessary.
