29
Network Camera User Manual
At any time of day or night, please make sure the image of the camera is clear and with
adequate and even light, avoiding overexposure or too much darkness on both sides.
4.4.1
Exception
This function can detect changes in the surveillance environment affected by the external
factors.
To set exception detection:
Go to Config
Event
Exception interface as shown below.
1. Enable the applicable detection that’s desired.
Scene Change Detection
: Alarms will be triggered if the scene of the monitor video has
changed.
Video Blur Detection
: Alarms will be triggered if the video becomes blurry.
Video Cast Detection
: Alarms will be triggered if the video becomes obscured.
2. Set the alarm holding time and alarm trigger options. The setup steps are the same as
motion detection. Please refer to motion detection chapter for details.
3. Click “Save” button to save the settings.
4. Set the sensitivity of the exception detection. Click “Sensitivity” tab to go to the interface
as shown below.
