31
Network Camera User Manual
1. Enable line crossing detection and select the snapshot type and the detection target.
Save Panoramic Picture
: If it is enabled, the detected panoramic pictures will be captured
and saved to the SD card when there are targets detected.
Save Target Cutout
: If it is enabled, the detected target cutout pictures will be captured and
saved to the SD card when there are targets detected.
Note
: To save snapshots to the local PC, please enable “Local Smart Snapshot Storage” in the
local config interface first. To save snapshots to the SD card, please install an SD card and
enable “Trigger Snap” first.
Detection Target
:
Human:
Select it and then alarms will be triggered if someone crosses the pre-defined alarm
lines.
Motor Vehicle
: Select it and then alarms will be triggered if a vehicle with four or more
wheels (eg. a car, bus or truck) crosses the pre-defined alarm lines.
Non-motor Vehicle
: Select it and then alarms will be triggered if a vehicle with two wheels
(eg. a motorcycle or bicycle) crosses the pre-defined alarm lines.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object/target is selected, alarms will not be triggered even if line
crossing detection is enabled.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as alarm in (sensor alarm) detection.
Please refer to
chapter for details.
4. Click “Save” button to save the settings.
5. Set area and sensitivity of the line crossing alarm. Click the “Area and Sensitivity” tab to
go to the interface as shown below.
Set the alarm line number and direction. Up to 4 lines can be added. Multiple lines cannot be
added simultaneously.
Direction
：
A<->B, A->B and A<-B optional. This indicates the direction of the
intruder/vehicle crosses over the alarm line.
A<->B
: The alarm will be triggered when the intruder/vehicle crosses over the alarm line
from B to A or from A to B.
A->B
: The alarm will be triggered when the intruder/vehicle crosses over the alarm line from
A to B.
