Paramount Fitness FP-541 HB, Instructions And Owner'S Manual

11

OPERATING INSTRUCTIONS

CAUTION

Do not attempt to operate until you  
have read and understand all General 
Safety Information in this manual and  
all assembly is complete and leak  
test has been performed.

BEFORE TURNING GAS SUPPLY ON:

Your appliance was designed and 
approved for outdoor use only. 
Do NOT use it inside a building, garage, or any other enclosed area.

2. Make sure surrounding areas are free of combustible materials, gasoline, and

3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections

are tight and there are no leaks.

4. Be sure the cylinder is clear of debris. Be sure any component removed during

assembly or servicing is replaced and fastened prior to starting.

1.

2.

BEFORE LIGHTING:

The appliance should be thoroughly inspected before each use, and by 

a qualified service person at least annually. 

If relighting a hot appliance, always wait 5 minutes with tank valve closed.
Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak tested. If the 
hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly 

specified b

y manufacturer. 

DANGER! 

FOR OUTDOOR USE ONLY

CARBON MONOXIDE HAZARD

Never use this inside a house, or other 
unventilated or enclosed areas. This appliance
consumes air (oxygen). Do not use in 
unventilated or enclosed areas to avoid 
endangering your life.

WHEN FIRE PIT IS ON:

Burner will display tongues of blue and 

not be yellow or produce thick black 
smoke, indicating an obstruction of 

should be blue with straight yellow 
tops. If excessive yellow 

flame is

detected, turn off 

fire pit and consul

t

the “Troubleshooting” section near the 
end of this manual.

LIGHTING:

1. Turn the control knob to “OFF” position. (Figure A)

2. (Natrural Gas skip to Step 3) Fully open LP cylinder valve. 

Note: For initial start or after any cylinder change, hold

Control Knob IN for 2 minutes to purge air from gas lines before proceeding.

3. Push in gas control knob and turn counterclockwise to “HIGH” (Figure B). Press igniter button. If needed, return gas control

knob to “OFF” and repeat these steps until 

the fire pit lig

hts (you should hear a clicking sound each time).

4. After the appliance lights, release control knob  If you want a lower temperature push in the control knob and turn

.

counterclockwise to the “LOW” Position (Figure C).

NOTE: If burner fails to remain lit, close all valves and wait at least 5 minutes for accumulated gas to dissipate before 

attempting to light.

OPERATING INSTRUCTIONS

 WARNING

Very hot while in operation!

Do not touch Table Top or Burner 

after use before placing Lid on Table Top 
or touching any surfaces. Failure to comply 
with these instructions may result in 
serious bodily injury.

a

Electronic igniter

requires AAA battery    

Standard igniter, 

no battery required 

NOTE

：

Some models have an Electronic 

Igniter and will require installation of 1-AAA 
battery.The battery should be installed by 
unscrewing the RED IGNITER BUTTON.

C

e

r

u

g

i

F

Figure A 

Figure B 

Contact us for assistance:  customercare@jrhome.com  |  (800) 561- 

5550