13
)'8+'4*3'/4:+4'4)+
To enjoy years of outstanding performance from your heater, make sure you perform the following
maintenance activities on a regular basis:
Keep exterior surfaces clean.
1. Use soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around the burner and control compartment
dry at all times. Do not submerge the control valve assembly. If the gas control is submerged in
water, do NOT use it. It must be replaced.
3. Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean.
Signs of possible blockage include:
Gas odor with extreme yellow tipping of flame.
Heater does NOT reach the desired temperature.
Heater glow is excessively uneven.
Heater makes popping noise.
Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater
and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner.
Compressed air may help clear away smaller particles.
Carbon deposits may create a fire hazard. Clean dome and burner screen with warm soapy
water if any carbon deposits develop.
Note:
In a salt-air environment (such as near an ocean), corrosion occurs more quickly than
normal. Frequently check for corroded areas and repair them promptly.
TIP (FOR STAINLESS STEEL MODELS):
Use high-quality automobile wax to help maintain the appearance of your heater. Apply to
exterior surfaces from the post down. DO NOT apply to emitter screen or domes.
Storage:
Between uses:
Turn control knob OFF.
Disconnect natural gas source.
Store heater upright in an area sheltered from direct contact with inclement weather (such as
rain, sleet, hail, snow, dust and debris).
If desired, cover heater to protect exterior surfaces and to help prevent build-up in air passages.
Note:
Wait until heater is cool before covering.
Service:
Only a qualified service person should repair gas passages and associated components.
Caution:
Always allow heater to cool before attempting service.
FOR YOUR SAFETY
*Do NOT touch or move heater for at least 45
minutes after use.
*Reflector is hot to the touch.
*Allow reflector to cool before touching.
WARNING
