7
'99+3(2?
Hardware Used: 4 -M6x12 Bolt
5.
Route natural gas hose (E) down into main/lower post assembly (D) by first removing
the large end of the quick connector, the yellow cap and safety papers.
Align 4 small holes on head assembly with
4 small holes in main post (F).
Note: there is a small piece of protective foam located in the neck of the heat assembly that MUST
be removed prior to attaching head assembly to the upper post.
6.
Assemble reflector panels (A) with reflector center cap (B).
Place 2 panels side by side and connect with bolts and nuts.
Repeat these steps until all four panels are assembled, then
locate the reflector center cap, and use bolts and nuts to connect
each panel to complete assembly.
5
6
Guide the hose through the main
post (D) from the top and out the
hole in the side of the main post
base.
Guide the hose
through the exit hole
on the base.
Replace the large part of the
quick connect, the yellow
cap and the safety papers.