Paramount User Guide
157
|
P a g e
Figure 86: The Set Motor Index Angles settings on the Utilities tab.
Reboot For Indexing
Click this button to restart the Bisque TCS so that DC servomotor’s unique
motor index angle
can be
measured.
RA Index
Enter the motor index angle for the right ascension motor.
Dec Index
Enter the motor index angle for the declination motor.
Measure RA (RA Button)
Click this button to measure the right ascension motor index angle. When measuring the motor index
angle, there can be no load on the motor, so you must remove the drive belt before proceeding.
Measure Dec (Dec Button)
Click this button to measure the declination motor index angle. When measuring the motor index angle,
there can be no load on the motor, so you must remove the drive belt before proceeding.
Save Indices to Bisque TCS
Click the button to save the
RA Index
and
Dec Index
motor index angles to the Bisque TCS firmware. The
motors and control system will not operate normally if the wrong motor index angles are saved, so please
double-check these values before proceeding.
Get Current
Click this button to reads the current motor index angles from the control system.
