Winterization
You will need the items in the winterizing/pressure test kit part number 005-760-2911-00
and tool 004-627-5452-00.
1. Turn off the water to the Paralevel.
2. Remove the Paralevel float assembly by grasping the top of the float assembly (above the
adjustment wheel and while pushing down turn the assembly counter clockwise a quarter turn.
The float assembly should then pull out. Next using the removal tool #10 on the Paralevel
exploded parts diagram (page 6), remove the Retainer Nut and Retainer Ring #19 and #20.
Next using a 3/8 inch socket wrench extension remove the Flow Plug and O-ring #17 and #18
on the Paralevel exploded parts diagram. (page 6)
3. Drain the water in the pool to below the opening for the equalizer line for the Paralevel. Place
the O-ring and Seal Plug #4 and #5 on the winterizing kit exploded parts diagram (page 7)
into the threaded hole that the Flow Plug was removed from.
Fig. 7
Fig. 8
Fig. 9a
Fig. 9b
USE ONLY PARAMOUNT GENUINE REPLACEMENT PARTS
4
USE ONLY PARAMOUNT GENUINE REPLACEMENT PARTS
