OPERATION
Preparation:
You will need to purchase a 1 pound propane cylinder before
you start to use.
Connect the cylinder with the inner regulator
Warning:
Always test the connection place leaks with soapy water.
Any guard or protective device removed for servicing the heater
must be replaced prior to operation.
Warning:
Never use the heater while it is raining, the glass tube would break when it
suddenly met water.
Always turn off the heater while there is a rain.
Never splash any liquid to the glass tube when the heater is working
The glass tube will be extremely hot when it is working, never try to touch it and
Keep the children away from the heater.
Always ensure the heater stands firmly, the glass tube may break if the heater was
fell down onto ground.
Never use the heater if the glass tube has any crack
●
●
●
●
●
●
LIGHTING INSTRUCTIONS
Check and ensure that an AA battery is inside the ignition
chamber and has power. Ensure
The anode (+) faces outside.
Ensure that the control knob is OFF. Slowly open the
gas cylinder valve.
Press and turn the control knob to LIGHT position,
push the igniter to generate spark while keeping control
knob in pressed position
Check for pilot flame through glass tube. If pilot does
not light, turn control knob to ‘OFF’ position wait two
minutes minimum and try again from the start. Some
attempts may be necessary.
If the pilot alight, keep control knob pressed for 15
seconds then turn the control knob to ‘LOW’.
For maximum heat turn control knob to ‘HIGH’.
To turn heater off, turn control knob to ‘OFF’.
Close the vlave of the gas cylinder or the regulator after
use.
1.
2.
3.
4.
5.
6.
7.
OFF
LIGHT
LOW
HIGH
OFF
LO
HI
WARNING
FOR YOUR SAFETY:
● DO NOT touch or move heater for at
Least 45 minutes after use.
● Allow all burner elements to cool
before touching.
NOTE
● In a salt-air environment (such as near an
Ocean) corrosion occurs more quickly than
normal.
● Frequently check for corroded areas and
Repair them promptly.
● Wait until heater is cool before covering.
- 10 -
