8
NOTE: It is most important that this appliance is installed correctly and that the operation is correct before
use. Installation shall comply with local electrical, fire and health and safety requirements.
PARAMOUNT MIXERS are designed to provide years of satisfactory service. Correct installation is
essential to achieve the best performance, efficiency and trouble-free operation.
This appliance shall be installed with sufficient ventilation to prevent the occurrence of unacceptable concentrations of
health harmful substances in the room, the appliance is installed in.
Installations must be carried out by qualified service persons only. Failure to install equipment to relevant codes and
manufacturers specifications in this section will void the warranty.
Components having adjustments protected (e.g. paint sealed) by manufacturer are only to be adjusted by an
authorised service agent. They are not to be adjusted by the installation person.
It is the responsibility of the owner to supply and arrange for the connection of all services to the oven.
On receipt of the Mixer, carry out the following:-
Carefully examine the packaging and the appliance for any signs of external damage that may have occurred
during transit.
Remove all packaging and transit protection from the appliance including all protective plastic coating from
outer panels.
Check equipment and parts for damage. Report any damage immediately to the carrier and distributor. Never
attempt to operate the machine with damaged parts.
Report any deficiencies to the distributor who supplied the appliance.
1. Select a location for the Mixer with a minimum of 0.6m space around the machine for operating, cleaning and
servicing.
2. Position the mixer in its approximate working position. The mixer must be installed on a horizontal, solid and dry
floor.
3. Install the four anchors and lifting feet supplied with your mixer. Make certain that, during the installation these
feet are completely supporting the mixer and that the weight of the machine is off the front and rear castor wheel
assemblies.
4. Adjust the mixer feet to ensure that the mixer is level and seats firmly on all four corners.
5. Also, during this procedure it is recommended that the mixer is levelled from front to back and from side to side.
This will ensure the greatest stability and mixing performance.
6. The final step in installation is to lock the anchor and lifting feet in place. This is done by tightening the locking
nuts securely to the mixer supporting strut.
Before installing the mixer, check that the available electrical supply match that of the mixer as stated on
the mixer’s rating plate.
Summary of Contents for SM2-25
