Parasit Studio
General builds tips
•
Solder the low profile components first, from short to tall.
Recommended order: resistors, diodes, IC socket, film-caps,
electrolytics, pots.
•
CMOS chips are very sensitive to static charges and can be easily
damaged. It's a good idea to wear a anti-static wristband or at
least avoid wearing a wool jumper and petting your cat/dog while
building...
•
Always use sockets for IC chips to avoid heating them directly. It
also makes it much easier to swap them out if needed.
•
Pay special attention to the orientation of the diodes and
electrolytics.
•
This PCB is designed for board mounted angeled pots, but if you
want to use regular solderlug-pots, the square holes represents pin
1 of the pot.
•
Cover the backside of the pots with pot covers or tape, so they
don't short out anything on the PCB.
The Quantum Defrakulator MK3 prototype
Summary of Contents for MK3
Page 8: ...Parasit Studio Schematic...
