Parasit Studio
Offboard Wiring
•
9V pad to DC jack positive lug (or battery clip +)
•
G pad to DC jack negative (or battery clip -)
•
O pad to output jack Tip
•
G pad to output jack Sleeve
If you want to drive this effect from a 9 volt battery, I recommend using
an extra switch (like a SPST, or a SPDT using two of the pins) as an
on/off switch, to disengage the battery while not in use.
CV jack Wiring
•
To hook up the CV (control voltage) input jacks, connect the CV pad on
the PCB to the tip of a 3.5mm jack (or jack of your choice). Make sure
that the sleeve of your jack is connected to ground (it usually is
connected to ground via the enclosure unless you have an isolated jack
type). If you use a stereo/balanced jack, just leave the ring lug
unconnected.
CV1 = oscillator 1 frequency
CV2 = filter cutoff
The CV input range is 0-9 volts, but 0-5 volts works great aswell.
Summary of Contents for MK3
Page 8: ...Parasit Studio Schematic...
