REAR PANEL CONNECTIONS AND CONTROLS
6
Connection Precautions
Disconnect the AC cord before and while making or changing any input, trigger, or speaker
connections. Make sure there is no strain or tension on any connections that could cause
them to pull loose.
Antenna Connections
The Ztuner v.2 cannot receive any FM or AM stations without separate antennas for each band.
Adequate reception and sound quality depend on antennas suitable for your location.
FM Indoor Wire Antenna
A standard FM “folded dipole” T-shaped flexible wire antenna
is included with your Ztuner v.2. It should be adequate for most
urban and suburban locations where there aren’t surrounding tall
buildings and/or hills.
Connect the 300
Ω
(ohms) antenna wire’s two spade connectors to
the screw terminals on the small 300
Ω
to 75
Ω
balun adapter. First loosen each screw and insert
a spade lug under each of the lock washers. Tighten the screws to hold the wires securely.
Push the balun’s plug carefully onto the round antenna receptacle marked FM 75
Ω
.
You should be prepared to adjust the position of the wire antenna to optimize reception. Clear
reception of certain stations may require a different antenna orientation, especially if there are
tall buildings and/or hills nearby.
Outdoor Antenna
For best reception with the least background noise, we vrecommend the use of a high-quality
outdoor FM antenna. Use round 75
Ω
coaxial cable from the antenna with an “F” connector (not
included) which you plug into the Ztuner v.2’s 75
Ω
FM antenna receptacle. If you use flat 300
Ω
twin lead antenna wire, use the balun adapter as described above.
Cable Transmission
Most cable companies transmit FM stations as well as TV. Check with your local cable company
about the availability of FM stations. The quality of FM radio varies widely among cable operators.
Your Ztuner v.2 connects the same way as a second television: Use a TV-FM signal splitter (not
included) with the incoming cable connection and connect one wire from the output of the splitter
to connect your television and the wire from the other output to the Ztuner v.2 FM connector.
Powered FM Antennas
A small powered indoor antenna is sometimes useful when it’s impractical to install an outdoor
roof-top antenna or where FM transmission is not available via cable or a community TV/FM
antenna. However, powered antennas can occasionally add noise and distortion. In many cases,
you will receive clearer signals with the supplied dipole wire antenna.
AM Antenna
Connect the two wires from the loop antenna to the Antenna terminals marked AM and GND.
Position the antenna for best AM reception.
Audio Out Jacks
Connect standard audio cables from the stereo L and R Output jacks to the Tuner input on your
preamplifier or system controller. You may connect the Ztuner v.2 to any line-level input, even if
the input isn’t labeled “tuner.” There is also a 1/8” (3.5 mm) mini jack for stereo connections.
The jack tip is L, the ring is R and the sleeve is ground.
There is an additional Mono output jack which is useful for zones where only mono speakers are
installed (such as hallways, small rooms). The Ztuner v.2 outputs stereo and mono simultaneously.
Attach to Ztuner 75
Ω
Antenna terminal
Attaches to
Antenna Wires
Summary of Contents for Ztuner v.2
Page 1: ......
