SafeAir™ M-600 Installation Guide
8
www.parazero.com
5
Open the six screws
connecting the power cables
(each connects two power
cables for two engine
controllers), spread in a
hexagon shape. Then move
the cables to the sides.
6
Place the TerminateAir above
the screw holes.
7
Make sure the board is
aligned with the buzzer and
two yellow connectors before
proceeding with the
installation.
8
Insert the 12 power cable
terminals onto the 12 screws
on the TerminateAir board. Do
not open the screws. Each
terminal has its own screw.
Make sure you connect it to
the right screw, as shown in
the figure below. Pay special
attention to the marking on
the board, indicating the GND
and VOUT and connect
accordingly: Red wire to the
VOUT (+), and black wire to
the GND (-).
Failing to do so, may create a
short circuit in the power
supply and damage the
drone.
