31
Installing
Deployment
The SafeAir Phantom includes an Autonomous Triggering
System (ATS) that identifies critical failures and triggers
the system autonomously. Should an emergency situation
occur, the system deploys the parachute, stops the rotors
and sounds an audio-warning buzzer to alert bystanders
of the falling drone.
In addition to the ATS, the SafeAir Phantom may also be
triggered manually by an external 3rd party RC.
The system can only deploy when it is in Armed mode
(green LED). Following a deployment, the LED turns red.
To switch to Standby mode, reset the system by turning
the power switch OFF and then ON again. The LED
should turn blue after approximately 20 seconds.
Summary of Contents for SafeAir Phantom
