- 42 -
Cleaning the base unit and the power adapter
• Wipe the housing of the base unit and the power adapter with a damp cloth.
NOTICE
The base unit contains the electrical controller, which
may be damaged by the pene-
tration of fluids
. Therefore, when cleaning, only the outer surfaces must be wiped with
a damp cloth. Do not spray any liquid on the base unit or the power adapter.
The base unit contains ...
If liquid has penetrated the base unit or the power adapter, the PARI SOLE N must not
be used again under any circumstances. Before using it again, you must contact the
PARI GmbH Technical Service department or the PARI Service Center [See also: 7.4
Contact].
Care of the connection tubing
Leave the connection tubing attached to the base unit so that the air line in the base
unit is also blown dry.
Leave the connection tubing ...
• Switch the compressor on.
• Leave the compressor running until any condensation in the tubing has been removed
by the air flowing into the tube.
• Turn the compressor off and remove the power plug from the socket.
Cleaning the nebuliser and accessories
• Thoroughly clean all components (except for the connection tubing and the base unit)
in warm tap water and dishwashing liquid for about 5 minutes. If necessary, use a
clean brush to remove loose dirt (the brush must be reserved exclusively for this pur-
pose).
• Rinse all parts thoroughly under warm running water.
• You can remove excess water more quickly by shaking all parts.
Follow the steps below to prevent the nozzle from becoming clogged:
• Re-assemble the nebuliser, plug the power plug of the base unit into the socket, and
switch it on.
• Fill with fresh, soft water, boiled if necessary, and nebulise the water until no more
aerosol comes out of the nebuliser.
