When cleaning excessively aggressive floors this may cause the machine to not work.
ain cap (22) to let water pour out to a
cleaned after each scrubber operation is
and turn the latch (17) to lock the tank.
Replace the recovery tank on the machine
he control panel (46).
means the machine is being overloaded.
T
his
indicators on the control panel (46) will flash simultaneously.
rush motor and vacuum
B
Before lifting the brush, turn it off by pressing the main switch (47).
Move the machine and start cleaning.
Pull one or both operating triggers (24), and then brush
turning the solution flow control lever (31) manually.
tion switch (50), the indicate light will be on.
Turn on the main switch (47).
pulling down the squeegee lift lever (26).
Set the handle to a comfortable height by pressing handle rotate lever (25).
dirty water into a container, or unscrew the solution tank dr
Turn the latch (17) off the recovery tank, ta
Solution Tank D
raining
Clean and rinse the recovery tank
bucket.
Open the lid (1) and overturn the recovery tank to drain the
Recovery Tank D
raining
Screw on the solution tank drain cap (22).
the solution tank. The solution/water
will flow freely into a bucket or floor drain.
Unscrew the solution tank drain cap (22) on the bottom of
the inlet (20) through pipe or bucket.
build up and clogging of the solution lines.
intended for automatic scrubber applications.
4
Turn on the vacuum motor switch (49), the indicate light will be on.
1. Fill water into solution tank (3) from
2. Do not fill the solution tank completely, leave a few centimeters from the edge.
3. The water temperature must not exceed 40
.
NOTE
1
．
2
．
Rinse the solution tank with clean water after every use. This will help prevent chemical
3
．
NOTE
1
．
ke off the recovery tank from machine by
grasping two grooves of tank.
2
．
with clean water after every use.
3
．
MACHINE OPERATION
1
．
2
．
3
．
4
．
Turn on the brush motor switch (48) and the solu
5
．
6
．
If necessary, adjust the water flow by
7
．
NOTE
.
CAUTION
！
CAUTION
！
Solution tank should be drained and
completed.
Recovery tank should be drained and cleaned after each scrubber operation is
completed.
If the battery indicator light (51) is green, the machine can be used. If it is yellow or red, the
batteries must be charged.
CAUTION
！
Use only low-foam and non-flammable detergents,
Lower the squeegee (33) onto the floor by
will start to spin, solution will begin to flow.
Please turn off all the switches on t
℃
