7
Switches 1 to 4 are electronic servo reversing
switches and should be adjusted to give the correct
control surface deflections relative to stick
movements.
The mix switch activates a ch1-ch2 mix to give
elevon (2 servos both functioning as ailerons and
elevators) for delta winged aircraft
For the Mirage the switch must be in the ‘Mix’
position
SECTION 3: ASSEMBLY
Locate the wing halves and fuselage assembly
Remove the protective tape from the wings and
fuselage and dry fit the wings and fuselage
together.
Apply adhesive on one wing panel and the mating
fuselage. Press into position and use tape or bands
to hold in place.
Wipe off any excess adhesive and allow to dry.
Repeat the procedure to the other wing.
Apply adhesive to the remaining wing root and
fuselage side. Press wing into position and use tape
or bands to hold in place.
Wipe off any excess adhesive and allow to dry.
Connect the aileron servo leads to the extensions
located in the fuselage matching black to black and
white to white.
Tuck wires into slot and apply self adhesive tape
over slot.
Repeat on opposite wing panel
Locate the main undercarriage assemblies, clamp
plates and fixing screws.
Insert undercarriage into mounting plate and fix in
place with saddles and four self tapping screws.
Repeat on opposite wing panel
Summary of Contents for Mirage 2000
Page 1: ......
