DHC-2 Beaver
www.
kmp
.c
a
DHC-2 Beaver
www.
kmp
.c
a
10
1. Ensure no parts are missing in the float kit. The kit should contain the following
items: (2) Pontoons, (4) Struts, (2) Cross Bars and (8) Screws.
2. If your aircraft already has wheels installed, remove them before assembling the
float kit, as you will need the aircraft to properly line up the floats the first time.
3. First place the cross bars in between the float struts. Do not glue the cross bar in
place until you have successfully screwed the struts to the aircraft fuselage.
4. Secure bottom of struts to the pontoons with 5 minute epoxy or foam safe ca.
(The front float contains a notch which should line up with the front struts before
glueing.
5. Optional vertical tail fin may be attached on tail. However if you wish to change
between wheels and floats it is recommended to not glue this piece in.
NOTE: WHEN USING FLOATS ON THIS MODEL IT IS RECOMMENDED TO ADD 2oz
OF WEIGHT TO THE NOSE OF THE AIRCRAFT.
