6
DHC-2 Beaver
www.
kmp
.c
a
DHC-2 Beaver
www.
kmp
.c
a
Picture3
暠
3
Picture3
暠
3
Picture4
暠
4
Picture4
暠
4
Picture5
暠
5
Picture5
暠
5
3.Please take out the main landing gear, and then take the landing
gear to insert the trough which is lied the back of battery cabin,
moreover it will be fixed by fastener.( picture 5)Note: If install
the landing gear incline the orientation of head cover, it will lead the
trail strength get shorter, so couldnt take off from the land.
2
.
After adjust the steel wire implement moderately,
then use hexagonal key to lock the screw tightly.
（
Picture
4
)
Picture6
暠
6
Picture6
暠
6
Picture7
暠
7
Picture7
暠
7
Picture8
暠
8
Picture8
暠
8
5
.
Battery
：a llow 2 S l ipo o r 7 S N IMHbattery,exorbitant p ressure w ill l ead t o t he m otor b urnt.
5
.든넥：連넣
2S
轉든샀
7S
퀑향든넥，법멕든箕삔돔鈴쯩댐쁑。
Picture9
暠
9
Picture9
暠
9
4. Please take the foreside of wing insert the bolt position
of fuselage accurately( picture6), then the magnet in the
back of wing will catch up the magnet in the fuselage,
so the wing installing procedure is finished( picture 7).
And if make the magnet in back of wing separated from
the fuselage lightly( picture8), after wards take out the
foreside of wing from the bolt position of fuselage, so
uninstalling procedure is finished( picture9).
1. If you have bought 4 channel transmitter of
ANL Cessna 182 Park Flyer, please take the BNC
connector plugs of wing auxiliary servo signal
string to insert the socket of the first vacant
channel on receiver.
2. Please install the batteries of transmitter, then
Picture1
暠
1
Picture1
暠
1
Picture2
暠
2
Picture2
暠
2
1. Insert carbon fibre rod into plastic centre spar brace
2. Glue carbon fibre rod and brace into left wing
3. Add right carbon fibre rod into brace
4. Connect wings together, while gluing right carbon fibre rod into wing,
as well as apply glue to all points of contact where spar and wing
halves meet
5. Check for proper alignment before glue sets
1. Use provided Y-lead servo extension to connect aileron servos
2. Align wing with top of fuselage
3. Attach wing strut to fuselage with the provided screws
4. Attach wing with the provided screw
5. If flaps are not used, apply tape to both sides of flap hinge line to
prevent flap movement
to receiver. (RTF Version only)
