AMPLIFIER OPERATION MODES
The amplifier can operate in two or one-channel modes (respectively: each channel
independently, the two channels in a bridge mode). The amplifier has two input channels.
Signals routing for four channels is performed by the
DSP
engine.
DSP
settings control, presets storing and the creation of the original signal
processing template is performed by personal computer with
SigmaStudio
editor,
installed to it.
Setting the high-pass filter and crossover filter parameters, EQ settings, desired
signal delay, as well as a number of other parameters can be performed by the DSP
engine, as described in
SigmaStudio
User Manual .
For the consumer’s convenience the amplifier has 8 presets, which provides a
number of the most frequently used switch configurations and settings.
DSP
presets
settings and block diagrams of the connections to the amplifier are in the Owner’s Manual.
Switching the amplifier
DSP
presets is performed by the
DIP
switch, located on the rear
panel of the amplifier.
12
