2
Connection Assignments and Functions
Connection Assignments and Functions
Connection Assignments and Functions
Connection Assignments and Functions
07-02-12-02-EN-V1215.doc / Type:
638
27
●
Feedback - Module X300 with Memory
As of firmware version V8.35 the 638 Drive supports the
X300-xM-Modules.
This module has an additional memory chip (Flash).
This flash stores the complete drive data. (firmware, function code,
parameters, application program)
When a drive is defect the X300-memory module can be replaced
with the complete drive data into the new drive.
You need no additional configuration work or software tools.
Requirement: The drive type must be equal (same current)!
638A
Attention during the 1st switch on of the control voltage
after the X300 module replacement!
After the replacement of the X300 module, make sure that the 1st switch on of
the 24V control voltage has no interruption during 60 seconds.
The 7- segment-display shows during this time:
- - - -
It is essential that the copy program for firmware and X300 Feedback function
code is not interrupted!
Applications in Accordance with the Regulations
When the 638A Drive supports the safety function “Safe Torque Off”, in the sense
of providing a definitive stopping of the equipment, with protection against
unanticipated start-up, in accordance with regulations EN954-1, Category 3 and
EN, after the X300 module change one must follow the instructions completely as
stated in the validation report.
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - info@sdsdrives.com
