Notes
on the Documents Supplied
Multi-axis devices
4
192-120148N5 June 2011
1.1
C3 ServoManager
The Compax3 ServoManager can be installed directly from the Compax3
DVD. Click on the corresponding hyperlink resp. start the installation
program "C3Mgr_Setup_V.....exe" and follow the instructions.
PC requirements
Recommendation:
Operating system: MS Windows XP SP3 / MS Vista (32 Bit) / Windows 7 (32 Bit / 64 Bit)
Browser:
MS Internet Explorer 8.x or higher
Processor:
Intel / AMD Multi core processor >=2GHz
RAM memory:
>= 1024MB
Hard disk:
>= 20GB available memory
Drive:
DVD drive (for installation)
Monitor:
Resolution 1024x768 or higher
Graphics card:
on onboard graphics (for performance reasons)
Interface:
USB 2.0
Minimum requirements:
Operating system:
MS Windows XP SP2 / MS Windows 2000 as from SP4
Browser:
MS Internet Explorer 6.x
Processor:
>=1.5GHz
RAM memory:
512MB
Hard disk:
10GB available memory
Drive:
DVD drive
Monitor:
Resolution 1024x768 or higher
Graphics card:
on onboard graphics (for performance reasons)
Interface:
USB
For the installation of the software you need administrator authorization on the
target computer.
Note:
Several applications running in parallel, reduce the performance and operability.
Especially customer applications, exchanging standard system components
(drivers) in order to improve their own performance, may have a strong influence
on the communication performance or even render normal use impossible.
Operation under virtual machines such as Vware Workstation 6/ MS Virtual PC is
not possible.
Onboard graphics card solutions reduce the system performance by up to 20%
and cannot be recommended.
Operation with notebooks in current-saving mode may lead, in individual cases,
to communication problems.
Your PC
is connected to the PSUP (mains module) connector X3 via an USB cable
(SSK33/03).
Start the Compax3 servo manager and make the setting for the assigned interface
in the menu"
Options: Communication settings RS232/RS485...
".
The interface is marked as "USB S
erial Port (COMx)" in the windows device
manager. The no. of the COM port "x" may vary. You can find it in the PC under
system control, system, hardware, device manager, connections.
Installation of the C3
ServoManager
Connection PC-
PSUP
