80
Gemini GV Hardware Installation Guide
Gemini GC-26 and GC-50 Connectors
Two breakout modules are available that connect directly to the Gemini’s
MOTOR FEEDBACK and DRIVE I/O connectors.
NOTE: These modules are recommended for system prototyping only—not for
permanent installation.
Description:
Part Number:
26 pin Connector/Breakout Module
GC-26
50 pin Connector/Breakout Module
GC-50
Dimensions are shown below.
CAUTION
Connect wires to the GC-26 and GC-50
before installing in the drive. This will avoid
damage that may be caused by wiring the connector while attached to the drive.
Dimensions in inches (millimeters)
GC-50
1
2
4
19
18
20 21 22
30
24
23
26
25
28
27
29
34
32
31
33
13
12
10 11
17
16
14 15
9
5
3
8
6
7
35
37
36
39
38
47
41
40
43
42
45
44
46
S
49
48
50
3.05 (77.5)
2.13 (54.0)
0.138 (3.5)
1
S
2
4
13
12
10 11
9
5
3
8
6
7
14
16
15
18
17
26
20
19
22
21
24
23
25
S
2.50 (63.5)
1.61 (40.9)
0.138 (3.5)
GC-26
GC-26 and GC-50 Dimensions
Gemini 26 Pin Feedback Connector Kit
A cable connector backshell kit is available from Compumotor. The kit includes
plug, cover, and all parts necessary to assemble the connector. It also includes
spade lugs to install on the motor cable. The part number is:
GFB-KIT
The plug mates with the drive’s 26 pin MOTOR FEEDBACK connector.
www.comoso.com